Page 1 of 1
PU Scope mount screw size
Posted: Wed May 11, 2022 9:51 am
by Hylander
Wasn't sure where to ask this.
Picked up a Pu scope and mount.
Not sure what size drill and tap I need.
Re: PU Scope mount screw size
Posted: Wed May 11, 2022 11:25 am
by millman
This is not the bubba resniper forum.
Re: PU Scope mount screw size
Posted: Wed May 11, 2022 11:57 am
by Hylander
First off this ain't a bubba job.
Second, like I said, I was not sure were to ask.
Third, if you can't be helpful, why are you an admin.
Re: PU Scope mount screw size
Posted: Wed May 11, 2022 12:32 pm
by millman
1st Please read the rules of the forum. 2nd There is no place on this forum for resnipering. 3rd I'm here to enforce the rules.
Re: PU Scope mount screw size
Posted: Wed May 11, 2022 1:21 pm
by Hylander
Ok got it.
Was just looking for screw size info and didn't know were to look.
Will try to looking elsewhere
Re: PU Scope mount screw size
Posted: Sun May 15, 2022 11:23 am
by Darryl
Hylander wrote: ↑Wed May 11, 2022 1:21 pm
Ok got it.
Was just looking for screw size info and didn't know were to look.
Will try to looking elsewhere
If you are just looking to ruin a perfectly good M91/30 Standard rifle with a fake setup, then why would it matter what size the tap is anyway?
Look at 1/2-13 .....
Darryl
Owner and Admin
Re: PU Scope mount screw size
Posted: Sun May 15, 2022 2:47 pm
by SA1911a1
Self drilling screws or just fire up the old Lincoln and burn a rod. A fellow could use epoxy, but it has to be the good stuff.
It is called how to spend a dozen hours and several hundred dollars to turn a $300.00 rifle into a $100.00 rifle.