The Russian Mosin Nagant Forum

hi .i just bought an sks with ati stock and after dissasembly and cleaning it a little spring fall on the floor and i dont know where it go.

I think magazine latch and sear spring. Look on U tube to see how to put it back. Will it snap on an empty chamber ? I think it's on the front, behind the crossbar that locks in.

hum this springs is already on place

Warpig wrote: ↑Sun Oct 11, 2020 1:39 pm hum this springs is already on place

Did you take the firing pin out of the bolt ? Hey I think it might bee the trigger bar spring. will it snap on an empty chamber. & return ?

this one? its in place.

Look up a schematic and find the trigger spring or trigger bar spring. It's internal in the trigger group.

ive not dissasembly the trigger group

This could be the spring that fits into the stock that secures the trigger group... But, it seems a little long...

qz2026 wrote: ↑Mon Oct 12, 2020 7:10 am This could be the spring that fits into the stock that secures the trigger group... But, it seems a little long...

That is what I was thinking too.

maybe you found the spring where the previous owner who did disassemble the trigger group and lost the spring put it in the weapon because he did not know where it came from either.....just a guess............

qz2026 wrote: ↑Mon Oct 12, 2020 7:10 am This could be the spring that fits into the stock that secures the trigger group... But, it seems a little long...

Warpig do you see a little hole in the bottom of the stock the spring will fit into ?