Enfield No2Mk1

[jaytex1969]

So, I have this old gun....

About 3 years ago, I snagged this revolver from a local pawn shop. Being primarily a bolt action rifle guy, I was flying blindly.

It's in really good condition, but it does seem to have a mechanical issue.



The hammer will not go back when the action is closed and the cylinder is properly aligned.

If the break action is open or the cylinder is between chambers, the hammer functions.

Technical info has been scarce. To add to the challenge, my understanding is that these were pre-"standardized" parts manufacturing, to an extent, and many pieces were hand fitted by competent craftspeople.

So, it's basically been a nice paperweight while in my possession.

If anyone can direct me to helpful info or resources, I'd be grateful.


Thanks.

Jay

[SA1911a1]

I wonder if the problem is associated with the cylinder that doesn't appear to match the finish on the rest of the gun?

[Longcolt44]

In researching my own 1943 No2Mk1** Enfield revolver I found it is imparitive to date it, see attachment. I notice the tag indicates it is in 38 caliber. This is not .38 Special as we know it. These revolvers were made in 38 S&W.

Enfield No2 Mk 1 Variants (1).JPG

[jaytex1969]

It's a 1934.

Having trouble posting/attaching images. That's why the image above is "linked" from another forum.


Jay

[Junk Yard Dog]

Size reduce the images down to at least 640x480 before trying to upload them to the board.