Question
Posted: Sat Jan 19, 2019 7:57 am
Will a V-24 fit in a K-98 stock ?
Military Preservation & Civilian Firearms Forums for Collectors
https://www.russian-mosin-nagant-forum.boydhouse.com/
https://www.russian-mosin-nagant-forum.boydhouse.com/viewtopic.php?t=31505
Does the K-98 have a stepped barrel ?Junk Yard Dog wrote:Going by memory, and that's spotty at best, the K98 uses the standard GEW98 large ring receiver while the 1924 Czech uses the large ring intermediate receiver that is slightly shorter. This will probably cause issues fitting it to a stock that isn't for a 1924, or VZ-24. I never tried the combination so for all I know the stocks may be cut for both receivers.
Actually JYD I'm pretty sure the VZ24 actually uses the exact same action length of a K98k it's the rear sight that's different. Atleast I've heard people claim that a VZ24 bolt will work in a K98 and vice versa. Theirs a couple posts on the gunboards forums about it. And a quick google search says the same thing but not my money to spend to find out. The people suggested to get a K98 bolt for replace on a vz24 didn't report back that it didn't work either so theirs that.Junk Yard Dog wrote:Going by memory, and that's spotty at best, the K98 uses the standard GEW98 large ring receiver while the 1924 Czech uses the large ring intermediate receiver that is slightly shorter. This will probably cause issues fitting it to a stock that isn't for a 1924, or VZ-24. I never tried the combination so for all I know the stocks may be cut for both receivers.
millman wrote:Vz 24 should fit fine. I know a Gew 98 fits a VZ stock. I stuck a poor butchered Gew 98 in a VZ 24 stock, and it looks better, if not right.