Little brass shavings *solution*
Posted: Sun Mar 25, 2018 3:22 pm
Hi all,
After loading ammo I used to paper-towel wipe each piece in case those little specks or crescent-shaped chips of brass were on the rounds. Today I packed a bunch of 9mms and there was no way I was going to do that due to volume, so I dumped them into a 30" wallpaper trough with a few cross-ways ribs in the bottom of the floor. Then I took a small shop vac with the round brush head and vacuumed them in a quick circular motion, including shoving them between valleys in the pan's bottom. This did really nicely and is way, way faster. Why didn't I come up with that 20 years ago??
Enjoy,
Aaron
After loading ammo I used to paper-towel wipe each piece in case those little specks or crescent-shaped chips of brass were on the rounds. Today I packed a bunch of 9mms and there was no way I was going to do that due to volume, so I dumped them into a 30" wallpaper trough with a few cross-ways ribs in the bottom of the floor. Then I took a small shop vac with the round brush head and vacuumed them in a quick circular motion, including shoving them between valleys in the pan's bottom. This did really nicely and is way, way faster. Why didn't I come up with that 20 years ago??
Enjoy,
Aaron