I got everything cleaned up, tightened and ready for the range but ran out of time on Saturday. Sunday I hit the range with the 20 rounds I had made up and was able to get the sights zeroed to the bullseye at 50 yards in 10 rounds. Took me longer to get it zeroed than it should have because I kept going the wrong direction! Lesson learned. That gave me 10 rounds to do a couple of 5 shot groups. The first group was decent but I wasn't as focused on my breathing as I should have been so I stringed it a bit. Still a respectable group but I knew this girl was gonna do better. The last group was much better. If I had stopped at a 3 round group I would have been very happy. It opened up a bit with the last two shots. Still, it showed that this rifle has a huge amount of potential and I just need to get more familiar with the diopter sights. This is my first with diopters so really not used to shooting with those other than a few shots here and there with Titanium Hammers CM .22's.
I will say, the trigger on this rifle is absolutely fantastic! I measured it and it is at 3 lbs 2 oz. Super light pull back to the second stage and then just a angels breath more to send the round down range. I'd read good things about the triggers on these but was really not expecting it to be this good.
Anyhow, here are some pictures of the rifle.
Left side of the rifle

Right side of the rifle

This one is a No-Maker, No-Date barrel. I was hoping that it would have been dated '72 since that's my birth year but beggars can't be choosers. It shoots well and that's more important to me.

Some of the rifles came with a scope mount base already attached and fortunately this one has it! Unfortunately getting the rest of the mount would cost me as much as I paid for the rifle!

A shot down the bore. Looks pretty good.

Most of these rifles were bedded and this one is no exception.

Not sure who made the receiver. Maybe a Remington?

The front sight with a .125 diopter insert. Works well with my Shoot-N-see's at 50 yards.

I only have the one front sight insert with the rifle, so I tried my hands at laser cutting a couple other ones for it. The one in the middle is the original. I made the other two out of black acrylic. They're a bit thicker than the original but look like they'll work ok. Making them the same thickness as the original made them way too brittle.

The rifle at the range

And last but no least, the best group I managed on the first outing. Can't wait to get it back to the range again this upcoming weekend and really see what it can do!




